Jump to content
JuztBudz

[TUTORIAL] DIY 5 gallon carbon air filter

Recommended Posts

Submitted By: JuztBudzSubmitted On: Jan 19 2012 03:58 PMSubmitted In: Grow Room Tricks and Tips:Click here to go to tutorial

Quote

Here is instruction for building an inexpensive 5 gallon carbon air filter...

 

Here a step by step filter construction that I am currently using. Prior to installing this filter you could smell my grow if you go within 25 feet of my house. Within 20 mins I couldn't detect the slightest odor unless you went in to the actual grow room... I have this filter set up a a single pass filter hooked up to my room exhaust. I have not noticed any temp rise or air flow reduction. I hope this will be beneficial to the 420 community. Enjoy

 

Materials needed

1 5 gal bucket w/ lid

4 gal of activated carbon pellets

3' section of 4" PVC drain pipe

1 roll of duct tape

1 section of flexible ducting

1 section of blue filter material

1 package of zip ties

1 4" pvc cap

 

Step 1

 

Drill holes in the sides of the bucket and PVC pipe. The more holes the better the air flow. (Note drill the bucket with a fast drill speed helps to keep the burrs down, and the PVC with a slow drill speed prevents the pipe from breaking.)

 

The end result should look like this you only want to drill holes in the pipe as high as you think the carbon will go you want the first hole in the pipe to be about 3"-4" submerged in carbon. If you drill to many holes simply cover the holes up with duct tape. You can use the PVC cap to plug the end of the pipe that will be in the bucket or just find something to plug the end. I used an empty sour cream container and silicone caulk.

 

 

Posted Image

 

 

 

Step 2

 

Place the end of the pipe on the center of the lid and trace with sharpie marker then cut out as carefully as possible with a razor knife. This is where the pipe will go through the lid you want a tight fit to prevent pipe from shifting in the carbon.

 

 

Posted Image

 

 

 

Step 3

 

You will need to cut the filter material to size and wrap the material around the pipe and the bucket, and secure it with zip ties. This will allow you to use larger holes for better air flow while keeping the carbon from falling through.

 

 

Posted Image

 

 

Step 4

 

Trim off excess zip ties

 

 

Posted Image

 

 

Posted Image

 

 

 

Step 5

 

Place the plugged end of the pipe in the bucket. Ensuring the pipe stays straight and centered pour carbon in filling the bucket around the pipe.

 

 

Posted Image

 

 

Posted Image

 

 

Step 6

 

Install lid and run a bead of silicone around the seam.

 

 

Posted Image

 

 

 

Step 7

 

Install the filter on you inline fan. if you have a 4" fan then it should be straight forward if you have another size you will need a PVC adapter to step up to your fan and ducting size.

Share this post


Link to post
Share on other sites

Just cutting them holes in that thing would have my hands cramped up for a month. That is a lot of holes! :) Glad I only have one neighbor on this side of the block and he is a MM user. Nice work

Edited by restlesslegs

Share this post


Link to post
Share on other sites

With a fresh coat of paint every couple a years it'll do just fine.

 

How often do they require switching out filters or charcoal? Can they be cleaned and reclaimed?

Share this post


Link to post
Share on other sites

Hey Gary,

So...you took time out from chess and buiit and compared this one to your phresh/can?

Yes, I used to use home made filters until I got tired of the smell.

Share this post


Link to post
Share on other sites

×
×
  • Create New...