Jump to content

Patient Seeking Assistance


Recommended Posts

I am current card holder with the plants in my name.

 

I have been on 3 yrs with the same specialist. As stated I have the plants in my name but the furnance went out this winter and my plants bit the dust. I am in search of clones and or seeds but perabably clones so I can get up and going again. I also need a solution while the plants get going again. I am not sure but I am sure I wont be able to buy any this month as I just dont have ANY extra cash flow at this time as I am on SSDI and work part time for myself. I am willing to trade services such as graphic design|logo creation and web development. I need to find a solution as I am in pain and need to get meds again. To make matters worse I have no car but am located just west of lansing in Eaton County so I can not come to you.

 

If you have any solutions to any of the issues I am having please contact me through the forum here and I will get back with you ASAP.

 

Thanks for your time.

 

RoCKeT-88

Link to comment
Share on other sites

RoCKeT-88 Please only start one thread for your topic. when you start more then one thread on a topic the mods have to come in behind you sand clean them up.

 

 

Your forum keeps timing out when I post so that is why but apparently the posts went through. Tyvm. I do run several forums so I know the procedures~

Link to comment
Share on other sites

Where are you located ? :unsure:

To make matters worse I have no car but am located just west of lansing in Eaton County so I can not come to you.If you have any solutions to any of the issues I am having please contact me through the forum here and I will get back with you ASAP Thanks for your time. RoCKeT-88

Edited by knucklehead bob
Link to comment
Share on other sites

So no one is selling clones uh ... ok. Must be some place to get some.

 

 

im not so sure why you had a probleme when he heat went out? did your lites go out also? did you not have any electricity? if so a 10 dollar litlle electric heater should have helped, Ive had plants in my garage in -2 with only a heating pad under the nute tub, and no probs, not saying it didnt happen, but when you spend the time to grow your own You must be prepaired for that kind of stuff, come on you dont know any one with an electice hearter that would have saved your plants, I keep a generator in my house at all times, I guess thats one of the good reasons to grow little grows that take care of me and more but can be run on my generator!

 

Good luck my frined, think out the next one a lil more!

Peace

Jim

Link to comment
Share on other sites

im not so sure why you had a probleme when he heat went out? did your lites go out also? did you not have any electricity? if so a 10 dollar litlle electric heater should have helped, Ive had plants in my garage in -2 with only a heating pad under the nute tub, and no probs, not saying it didnt happen, but when you spend the time to grow your own You must be prepaired for that kind of stuff, come on you dont know any one with an electice hearter that would have saved your plants, I keep a generator in my house at all times, I guess thats one of the good reasons to grow little grows that take care of me and more but can be run on my generator!

 

Good luck my frined, think out the next one a lil more!

Peace

Jim

I swear you sound like my hubby. We have 8 extra bulbs just in case a light goes out.last time I counted we had 3 fans in boxes just in case.and of coarse a generator .always be prepared grasshopper. Sorry not even close to lansing :blink: many good folks here hopefully someone can spare a few clones.maybe they can meet you at the protest.

Link to comment
Share on other sites

I just traded some clones and the drive wore me out, hence tons of computer time the past day and half, I'm too far to drive right now. Know how it goes I am on SSD myself and there is not much money even to live on. I have to get a driver if I go anywhere so it is a pain.

 

I need a back up fan but just had to replace it and bought some bulbs off eBay. Wouldn't you know that the fan blew after I put in one of the new lights, It was during a light 12 hour cycle and it fried my plants. Wish I could help you out and hope your able to find some help.

Link to comment
Share on other sites

im not so sure why you had a probleme when he heat went out? did your lites go out also? did you not have any electricity? if so a 10 dollar litlle electric heater should have helped, Ive had plants in my garage in -2 with only a heating pad under the nute tub, and no probs, not saying it didnt happen, but when you spend the time to grow your own You must be prepaired for that kind of stuff, come on you dont know any one with an electice hearter that would have saved your plants, I keep a generator in my house at all times, I guess thats one of the good reasons to grow little grows that take care of me and more but can be run on my generator!

 

Good luck my frined, think out the next one a lil more!

Peace

Jim

 

Well let me just tell you the whole story since you seem quite interested in it. lol :devil:

 

 

Yes the furnance went out(it's still not working if you want to verify the story) and time I got around to get a heater it was all over as I have to find someone to take me etc and it was during that one cold snap and they did not fair well at all.

Secondly I was having issues with the cloning process itself which I am not going to give every little detail on this as it's not important but I can if you want to hear about it.

Third after all this I had a ballast go out and was able to get another still have to get another one but I have time as its warmer and the winter bills are over now.

 

Thanks for your advice and next winter I will be more prepared trust me.

 

If you need any further information please feel free to ask and I will try my best to accommodate you just as soon I as I can~ LOL :rock: :rock: :rock: :rock:

Link to comment
Share on other sites

Just be careful, as far as I can see, the transfer of clones is not covered by the MMMA. I know I certainly wouldn't be making, or even seriously talking about participating, in this type of transaction on a public forum board. That's just me though.

 

I am fine with the MMMA and how the rules are written. I have the clone|cut issue solved now though I believe so it's all good. :phew: :phew: :phew: Thanks though I do understand you have to be careful and being careful is always the best policy.

 

Take care now.

Link to comment
Share on other sites

Just be careful, as far as I can see, the transfer of clones is not covered by the MMMA. I know I certainly wouldn't be making, or even seriously talking about participating, in this type of transaction on a public forum board. That's just me though.

You are correct and I should have not said that myself. PM instead. :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...